RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
1995 County LWB, 2006 MkIII / L322h
Joined
·
26 Posts
Discussion Starter #1
Hello everyone - this forum has been wonderful, with folks so helpful.

I was throwing a P0695, "Fan 3 Control Circuit Low", and decided to replace the fan clutch. A bit awkward, but the right tools and some time and I got it replaced. What's interesting is this: Most times (not all) when I start it from cold, the fan engages at full blast, and stays on until I'm going 10-15 mph. Then, it quiets down and seems to behave. Temperature gauge shows a normal warm up. Like most things RR, it doesn't always do it... And of course, the P0695 code is back. Any thoughts on what to check? I've replaced the main thermostat as well as the secondary thermostat.
 

·
Registered
1995 County LWB, 2006 MkIII / L322h
Joined
·
26 Posts
Discussion Starter #2
Such an unusual error / it really only does it when it’s a cold start.
 
1 - 2 of 2 Posts
Top