RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Starting a thread to gather intell from the pros here.

Just shelled out 350 bones to Atlatic British for head gasket kit, bolts, and an oil pan gasket. My oil pan unfortunately has almost as much water in it as oil. It runs great, no overheating, but blowining plenty of steam and lots of water draining in block.

My hope is that the bottom end is good and I'll resurface the heads and reinstall.

Looking for best pratices and advice on the process. Sounds like it is easier to pull the engine instead of just the top end off?

Thanks in advance.
 
1 - 2 of 2 Posts
Top