Joined
·
1,248 Posts
I am having a massive electrical issue and I need the wiring diagram for the hard dash Classics. SO if you have one please email me the file to [email protected] or post up the link on here. Thanks alot.
Wire diagram for hard dash Classic
Join the discussion
Recommended Reading
-
identification number
Range Rover Classicwhere on a early range rover are the front axle and chassis numbers ive been under the car for ages looking wire brushed nearly most of the front outside edge of the chassis and the right hand side axle front , found the back axle . Are all engine number stamped in a continues line ,its only I...- 0
- 26
-
Door Won't Unlatch From Inside or Outside
Range Rover ClassicI swapped door handles due to another outer aluminum lever failure (my 3rd?)... I adjusted the rod on the outer latch a bit tight probably, but tried the door a few times, and it worked like a champ. Then buttoned everything up, closed the door and it wouldn't unlatch using either the inner or...- 11
- 636
-
Rear spring recommendations- Steel spare tire bumper
Range Rover ClassicSo my 93 has a bit of a lean to one side as a result of my steel spare tire bumper. I have recently replaced my shocks with bilstein's but that did not fix the problem. I am wonder what spring I should use in the rear. I don't really want a lift, but want the truck to sit level. I also dont want...- 10
- 189
-
93trctdi · updated
-
Just another 88 Range Rover Classic build thread...
Range Rover ClassicWell after much waiting, haggling, and general unpleasant conversation with two of the biggest assholes I have ever met, I managed to acquire my first Range Rover a few months back. I would drive by this sad beast often, and could tell it was a few months or years from winding up in a...- 18
- 287
-
88POS · updated
-
Jumped Brake Switch- Now wont start
Range Rover ClassicSo, after randomly getting the ‘stuck in park..no brake lights’. I removed the brake switch connection, and used a 12v battery to connect 2 wires to allow the shifter to move into neutral. That worked. Yay. But afterwards, (and using jumper cables) i went to restart, and plenty of cranking...- 6
- 114
-
Gmerlino304 · updated
Join now to ask and comment!