As the title suggests around 95-100Kph I get a noise right above the windscreen in the centre of the vehicle.It sounds like wind coming up under windscreen protecter strip. I checked the strip and it has no play in it and is very firm so I have ruled that out, its no big deal just bloody annoying. Not sure what else I can check?
WInd noise around 100Kph
1 - 5 of 5 Posts
Joined
·
308 Posts
I had a vibrating buzzing noise at highway speeds from the windshield. It turned out to be the plastic part that clips on over the top and bottom edges of it.
1 - 5 of 5 Posts
Join the discussion
Recommended Reading
-
Key sync problem
Range Rover Mark II / P38Hello fellow P38 enthusiasts, my car is acting up once again. Yesterday i parked it at a shop, came back 10 minutes later and the car doesn't start anymore. Engine is immobilised and key fob doesn't lock or unlock. I tried synching the key via the door handle method and also i left the key in...- 3
- 73
-
P38 trim needed
Range Rover Mark II / P38I just acquired a low mile 22k 99 green on lightstone p38. It’s great but the front driver’s side and passenger side scuff plate by the door sill are cracked and the license plate light trim is also cracked. The rear E pillar has a slight scuff also. Any chance anyone has any of these parts in...- 4
- 222
-
ccr2002 · updated
-
locked out of my 2000 Range Rover HSE
Range Rover Mark II / P38Hi all! I am completely locked out of my Rover. The battery is not dead. The key fobs haven't worked for some time and I just enter with the key each morning locking an unlocking manually. I sent my kid down to open the door last week and she tried and tried so I believe the car went on super...- 17
- 402
-
At my wit's end
Range Rover Mark II / P38So here's the story, have just had all the rocker arms, timing chain, cam followers, camshaft machined, all to get rid of the damned ticking that has plagued my poor rover for months. But now the ticking is back and worse than before the work was done. I don't know what the issue could be, and...- 18
- 526
-
Take the guesswork out of valve block rebuilds
Range Rover Mark II / P38If you’re like me and had your valve block in and out a few times chasing leaks, this might help. A mountain bike shock pump on an emergency inflation schrader valve with a bit of 6mm air pipe. With the valve block in the car I was able to identify the leaking solenoid. When I replaced the...- 2
- 226
Join now to ask and comment!