Does anyone know the thread size on the valve block where the silencer/exhaust fits.
I have replaced them with gen units in the past but have seen much better type units stainless brass etc that can be cleaned and only cost a few quid.
Any help greatly appreciated.
P.S I have just tried 1/8 and 1/4 bsp, ones to small the other to big.
I have replaced them with gen units in the past but have seen much better type units stainless brass etc that can be cleaned and only cost a few quid.
Any help greatly appreciated.
P.S I have just tried 1/8 and 1/4 bsp, ones to small the other to big.