RangeRovers.net Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
150 Posts
Discussion Starter #1
I have a1993 LWB that has a Temp Sensor in the top radiator hose. Got a new hose and sensor from AB and installed. However, it is leaking at the sensor. What should I used to reistall the sensor to prevent it from leaking? Loctite?

Thanks

Parker
1993 LWB Plymouth Blue
 

·
Registered
Joined
·
1,395 Posts
Not sure if you can get it over there, but i've used a clear blue gel like sealant called Hylomar/Hylomar Aero Grade to good effect, it doesn't fully set like some sealants and so retains some pliability.
 

·
FOUNDING MEMBER
Joined
·
84 Posts
Did the sensor come with a new crush washer/gasket?
If not, I'd suggest using Hondabond HT, this is a great sealant the resists most under hood chemicals including oil and gasoline.
I love this stuff and always I always have a few tubes in the garage.

I like Hylomar and use it solely on parts that come apart often.
 
1 - 3 of 3 Posts
Top