RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
2002-2005 Range Rover MkIII / L322
Joined
·
8 Posts
Discussion Starter #1
Hi all, well I’m in need of some help. Just bought a reach motor, driveshaft spindle and nylon mounting bracket. As there was not a reach motor when I bought the RRV I’m not sure how to fit, unlike the tilt motor all done in 5 minutes, so is there a set way to assemble and fit, as there not much room to manoeuvre and of course I want to get it right as these parts are not cheap and the spindle is hard to get. Any way any help would be greatly appreciated.

thanks in advance.

Hayden
 

·
Registered
Joined
·
2 Posts
Hi all, well I’m in need of some help. Just bought a reach motor, driveshaft spindle and nylon mounting bracket. As there was not a reach motor when I bought the RRV I’m not sure how to fit, unlike the tilt motor all done in 5 minutes, so is there a set way to assemble and fit, as there not much room to manoeuvre and of course I want to get it right as these parts are not cheap and the spindle is hard to get. Any way any help would be greatly appreciated.

thanks in advance.

Hayden
Have you found a solution to this? I'm in the same boat that your in.
 
1 - 2 of 2 Posts
Top