RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
658 Posts
Discussion Starter #1
So I got a non corroded upper rear tailgate in the correct colour - unfortunately the courier smashed the glass so whilst I wait for its replacement thought I’d take off useful bits. So, motor off seals clips 2 buckets of glass vacced up But I see a potential huge problem in fitting the replacement- the loom has been chopped off where it enters the tailgate which is easily threaded through but I can’t see any way of getting the heated window wires and the number plate light loom in with the glass in place as it seems to run down the edge and at the corners see huge issues threading the loom in. Am I missing something cos at this moment I’m seriously considering just not bothering to fit the replacement
 
1 - 2 of 2 Posts
Top