RangeRovers.net Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
8 Posts
Discussion Starter #1
I have reassembled my p38 after replacing the heater core and found the clip below (see photo) not replaced.
It's probably in the center console.
Can anyone tell me where it goes and what it does so I can determine whether or not to do the work to replace it.

Thanks

IMG_1131.jpg
 

·
Administrator
Joined
·
27,800 Posts
Re: Reassembled P38; have extra metal clip; proba bly console???

Glove box latch retainer? If both sides look nice and clean it may just be an extra piece that was dropped during manufacturing.
 

·
Registered
1995-2002 Range Rover P38A
Joined
·
59 Posts
Re: Reassembled P38; have extra metal clip; proba bly console???

If that clip is about 3 inches wide it looks very similar to what is used to hold the side dash vents in place
 

·
LEGACY VENDOR
1995-2002 Range Rover P38A
Joined
·
2,064 Posts
Re: Reassembled P38; have extra metal clip; proba bly console???

P38Drive nailed it! I actually leave them off so I can pull the vents out and clean them..
 
1 - 6 of 6 Posts
Top