Range Rovers Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
264 Posts
Discussion Starter · #1 ·
Well,
After a few months of the car sitting idle I have just acquired a 325 TDS engine complete for £100 (Local breaker had it forever and doing a clear out).

Can anyone give me a blow by blow account of how easy / difficult it is to change the engine please?

From reading here I think I need to take the sump and oil pick up pipe from the Range rover engine and swap with the 325 Engine.

Is there anything else I need to swap ie ref aircon pump etc?

The car is an auto so I assume I have to release the torque converter first so that stays in place. I have a Workshop Manual but that shows removal with trans attached.

Any advice would be appreciated. I think it's about time the old girl breathed again!

Thanks

Ray
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top