[Ace 95]

Can anyone help me figure out what this code means? I took it to autozone and thats the reading im getting --

Their device said Manufacturer Control - Fuel Air Metering

I thought 02 sensor but the guy at a-zone says no.

:snooty:

 

[Ace 95]

http://www.rangerovers.net/forum/viewtopic.php?f=2&t=14964

Phil

Oxygen Sensor System too Lean Fault Banks A & B - so this means i need to replace a hose? which hose?

thx

 

[Ace 95]

is this an easy fix? can i do it?

where can i get the hoses?

thanks guys.

 

[Ace 95]

[quote="Ace 95":3e7qudir]is this an easy fix? can i do it?

where can i get the hoses?

thanks guys.

It's an easy, but messy job that's well within the scope of anyone who can use a screwdriver... You're basically just taking two hoses off and putting two new ones on, not difficult at all. Mine was made more complicated by the fact that some of my LPG pipes run over the top of the engine and got in the way a bit, I also didn't buy the genuine hose (as it will just dissolve again). Any autofactors should do hose, you want 19mm internal diameter hose - one end is 21mm so you have to soak that end in hot water to soften it up to be able to stretch it.

All in all, you'll need 2 meters (overkill but incase you cut the first too short etc) of hose and 4 new jubilee hose clamps (buy a 5th because sometimes you get a dodgy screw)[/quote:3e7qudir]


would the local autozone have these hoses? is there any diagram that shows exacty which 2 hoses it is?

thanks.

 

[Ace 95]

Should be relatively self explanatory here: http://rangerovers.net/forum/viewtopic.php?f=2&t=28533

nothing there on where to get the hoses.... :?

 

[Ace 95]

is this something that needs attention soon or can it wait? the light has been on now for about a month ive just been busy. :x

 

[Ace 95]

is this something that needs attention soon or can it wait? the light has been on now for about a month ive just been busy. :x