[g00dspeed]

Ok, so I replaced my oil pan gasket and that is all good to go. No leaks. Turns out that wasn't my main source of leaks.

With the engine on, I can see oil seeping right out from the middle of the bottom pulley (is this the front engine seal?) and it runs right down to the oil pan and drips from there....

If I rev the engine, it leaks worse...from what I can tell, that is the front engine seal? http://www.roverparts.com/Parts/ERR6490.cfm

If that is it, is there a write up on replacing those? Is it a hard item to replace?

Secondly, I'm getting oil leaking out from the plate behind the oil pan that is on the tranny. I thought that was just a cover plate for the pressure plate/etc..., but oil is leaking out the seal for that....is there even suppose to be oil in there? Could that signal a rear seal leaking? I don't even want to know how hard that is to replace....

Thanks for some info?

 

[g00dspeed]

sounds like fun....the water pump was recently replaced....

I wonder if the cam sensor or temp sensor can be replaced without removing the front cover?

As far as the rear seal, there is oil leaking from the bell housing cover...

at this point I might just go buy rebuild in a can .......

 

[g00dspeed]

thanks for the info....i have one more for you.

I've also got a massive leak where the front driveshaft goes into the transmission... what part is this called. Pinion Seal? Do you have to have any special parts to replace this seal?