RangeRovers.net Forum banner

MSD ignition

Jump to Latest Follow

1 - 4 of 4 Posts
T

·
Registered
Joined
·
2 Posts
Discussion Starter • #1 •
I am currently installing a full MSD ignition into my '93 LWB 4.2. Anyone who has any helpful suggestions/tips regarding installation and subsequent timing of this set-up please advise.

MSD 6AL controller/MSD Blaster coil/MSD 8548 dizzy

Thanks!
 
D

·
Registered
Joined
·
269 Posts
#2 •
No tips but I am interested on how it turns out. How much did everything cost, are you keeping the EFI or switching to carb?
 
1 - 4 of 4 Posts
Recommended Reading
Read More

  1. Door Handles

    Range Rover Classic
    I was getting pretty frustrated with the exterior door handles on my 92 RRC, and found that replacements (typically from ebay, pulled off donor cars) were ridiculously expensive and also, did not guarantee longevity as the same problem likely could occur down the road. I have very little trust...

  2. Just another 88 Range Rover Classic build thread...

    Range Rover Classic
    Well after much waiting, haggling, and general unpleasant conversation with two of the biggest assholes I have ever met, I managed to acquire my first Range Rover a few months back. I would drive by this sad beast often, and could tell it was a few months or years from winding up in a...

  3. 1995 RRC 4.2 Issues

    Range Rover Classic
    I've got a 1995 LWB that I've been trying to get running well enough to use as mu commuter in the winter when the Defender heating just doesn't do the job. The vehicle does this: Start from cold, drives for about 3 miles when the temp is just coming up to normal, if this happens while you pull...

  5. Atlantic british

    Range Rover Classic
    Just throwing this out there Each to his own.. But Atlantic British has updated their site Lots of stuff ... seems like they have more... anyway it’s good to have parts options ...

  6. How to remove front crank shaft pulley?

    Range Rover Classic
    I have some leaking around the front case of my engine and want to replace the sealing. But got stuck in the process when I got to the front pulley on the crank shaft. How do I remove it? What tools do I need? I tried measure the dimensions of the head of the screw, 34 mm. Is that correct...
Read More
About this Discussion
3 Replies
3 Participants
Last post:
rufant
RangeRovers.net Forum
We’re a community forum to discuss and assist on issues with every Range Rover model. Sign up if you have a question, answer or to meet like minded individuals
Full Forum Listing
Explore Our Forums
Range Rover Mark II / P38 Range Rover Mark III / L322 Range Rover Sport / L320 Range Rover Classic Range Rover Sport II / L494
Popular Communities
Community avatar for Mountain Bike Reviews
Mountain Bike Reviews
450,000+ members
Join
Community avatar for Home Improvement
Home Improvement
290,000+ members
Join
Top