Range Rovers Forum banner
1 - 2 of 2 Posts

284 Posts
Discussion Starter · #1 ·
All, my EAS air tank hose connection has a leak and I purchased and installed a manual filling system for the air springs.

I have them filled to about 100 PSI rear is 34 inches from the ground to wheel arch and the fronts are 33 8/16 inches from the ground to the arch.

I thought I read someone post that they only put a max of 80 PSI into the air springs....so I was not sure 100-120PSI was too much.....? :think:
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.