Range Rovers Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
68 Posts
I got a buddy of mine who runs a metalwork shop to mill me up a jack adaptor from a piece of solid round stainless steel billet.

I based the adaptor on this drawing posted on the Disco3 Forum………



I made sure that the lower, thicker shaft, was the correct diameter to suit the hole in my particular model of floorjack. I also increased the 15mm thickness of the pad, to about 25mm, just to give a little extra lift.

I’ve used the adaptor several times on both the RRS & D3 & it works perfectly, as well as giving a greater sense of security, knowing that the vehicle can’t slip off the jack.

Here’s a pic I just took of the apaptor on my work bench……..



….& one of the adaptor fitted on my jack.

 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top