RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
HI, I got my first Range Rover 4.4L l322 2002 week ago, with lost keys. I replaced the ignition switch, alarm module and ECU from a donor car and the Engine fired up. Someone had attempted this repair before me, and I noticed 18 pin connector to left side of the gear selector. Anyone here know what this connector is post to be connected to?
Thanks
s-l1600.jpg
 

·
Registered
2006-2009 Range Rover MkIII / L322
Joined
·
1,194 Posts
I think that is connector C0846 and it connects the main air conditioning HEVAC control module to the to the Rear HeVAC control board in the back of the console (its the board that controls the rear fan in the back of the console speed. That connector is a major pain to get disconnected from its mating half unless you know that that lever on the side is there. The mating half is white and its mounted on a cross bar in the top half of the console just in front of and below the ashcup/cupholder in the console (not the fold out cup holder, but the one between the cubby and the shifter panel).
 
1 - 2 of 2 Posts
Top