RangeRovers.net Forum banner

1 - 4 of 4 Posts

·
Registered
1995-2002 Range Rover P38A
Joined
·
36 Posts
Discussion Starter #1
Is the hard rubber mount for the lower height sensor arm replaceable? I am looking for the attachment point from the lower sensor arm to the suspension(rear radius arm).

Ive searched for a replacement but I haven't had any luck and I haven't seen any diagrams indicating a part number either.

I am hoping it is easily replaceable.

Thanks in advance!
 

·
Super Moderator
Joined
·
2,311 Posts
It's bonded to the radius arm so isn't a separate part that can be changed. I suspect you may have to fabricate something on a clamp that can go round the arm. Don't even think about drilling and tapping into the arm, it's a composite component and any mods could seriously weaken it.
 

·
Registered
1995-2002 Range Rover P38A
Joined
·
1,433 Posts
No. I had a similar problem and couldn't source one.
I was a bit heavy handed when removing a height sensor on the rear and I tore the rubber mount. I ended up buying another trailing arm from a breakers.
 
1 - 4 of 4 Posts
Top