Gear shifter linkage

I have searched the for the answer but couldn’t find any figured I’d make a new thread. I got to replacing fuel filter and o2 sensors and it was a job, I’m going back to saying it’s a bad design on a fuel filter, sorry RRToadHall. Anyways, as I was replacing the downstream o2 sensor on bank 1 i wasn’t expecting it to brake loose as quickly as it did.. and I hit the linkage with a wrench. I know when everyone replaces theirs they mark the location on the old one but now I’m getting resistance when I shift into drive and I’m worried I might have moved it a tiny bit. I have no reference to use for where it should be. Do you guys have any measurements by any chance? Thanks