Range Rovers Forum banner
1 - 3 of 3 Posts

·
Registered
1995-2002 Range Rover P38A
Joined
·
865 Posts
Fractures, cracks and breakages can be caused by a number of issues.
Inferior replacement with a non brand cheap knock off type. (stuff from the east)
Incorrect fitting, forced on/knocked on with a hammer.

Then the best bit, vibration which can come from numerous other components including prop shaft.
 

·
Registered
1995-2002 Range Rover P38A
Joined
·
865 Posts
I would have thought poor casting quality would be to blame, then also over tightening the tensioner would over stress this area too.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top