RangeRovers.net Forum banner

1 - 4 of 4 Posts

·
Registered
1995-2002 Range Rover P38A
Joined
·
193 Posts
Discussion Starter #1
Good morning,

I am new to this forum, so pleas ebear with me. I purchased a 99' 4.6 back in January. The EAS was shot, so I switched over to springs/shocks. My question is; can I now take all the EAS stuff off (i.e., compressor, valve block, etc)? If so, what do I need to do? I am sure there are wires I need to ground or cap... Any help would be greatly appreciated.

Bob
 

·
LEGACY VENDOR
Joined
·
2,492 Posts
Don't touch anything `) Many people of this board reconverted their range rover to air suspension after some steps in the dark side.
 
1 - 4 of 4 Posts
Top