Range Rovers Forum banner

EAS valve block rebuild HELP

1988 Views 8 Replies 6 Participants Last post by  PaulP38A
SO today I decided what the heck to play it sae let me rebuild the whole valve block, so everything went find and I put the valve block back into the car started her up and nothing happeded I then sprayed some soapy water on and it appears that the compressor is running fine but a lot of air is going straight out the exhasut on the block but when I remove the line that goes to the tank there is pressure and air in the tank,when I was putting the new o-rings in I was using vaseline and put some on the no return valves as well as the diaphram could this have an effect on the air pouring out the exhaust?
1 - 1 of 9 Posts
JeremyD said:
I was following the steps in this post

will wait and see what the experts have to say
Well the procedure you followed warns against using vaseline on the NRV,s.So I guess it causes problems if you do. :naughty:
1 - 1 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.