Range Rovers Forum banner
1 - 1 of 1 Posts

·
FOUNDING MEMBER
Joined
·
4,509 Posts
don't put the collet on the line first, pushing it through the hole will crimp the tube enough that the airline can pull out under pressure.

Just shove it into the collet in the airspring. Pulling it up with the screwdriver actually makes the collet tighter. the inside of the hole is tapered to tighten the collet on the line as it pulls back out because of air pressure, so that bit of play is needed. leave the collet flat against the spring portion of the fitting.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top