Range Rovers Forum banner
1 - 3 of 23 Posts

· JACK'S GRANDAD
Joined
·
9,310 Posts
Contact Arnott and get some new collets on the way. Hell I may even have some around here fro GenII bags.
Another thought is to use some 1/4" airline to the bag, as it is slightly larger than 6mm.

Martin
 

· JACK'S GRANDAD
Joined
·
9,310 Posts
Not really sure why it would not just rise off the blocks, unless a height sensor isn't happy for some reason.
If it is sat on blocks and they are all at the right heights, it should just inflate that one bag, then the rest to level it up to the programmed height. I think anyways.........but we know how that goes at times!
I'll swap you headaches though, as I need to make new motor mounts for this little 6.0 engine, as the Rover ones are no where near strong enough apparently

Vehicle Engine Auto part Car Automotive engine part


Martin
 

· JACK'S GRANDAD
Joined
·
9,310 Posts
ahh, welding, fabrication, machining....that's a headache I'm envious of, give me metal work over electrical any day :wink:
Agreed!

Martin
 
1 - 3 of 23 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top