RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
1995-2002 Range Rover P38A
Joined
·
3 Posts
Discussion Starter #1
Probably missed this from an earlier thread, however new issue to me. EAS remains in full height position, with the "do not exceed 35 mph warning and EAS fault showing. Any helpful ideas on where to start looking? Also, would very much like shupack's website, as I was going to replace the valve block o=rings. the "bete-noir" has 124k miles on it and pretty certain has not been done. Have replace all springs with Arnott's gen II units. Thanks for the help. This forum has given us a wealth of information in a welcoming and accepting manner not found in many others.
 

·
Super Moderator
Joined
·
2,319 Posts
Read and reset the fault. On most faults the suspension drops to the bumpstops but under certain circumstances it rises to full height and stays there. It needs to be reset.
 
1 - 2 of 2 Posts
Top