Range Rovers Forum banner

Dog Guard

2K views 10 replies 6 participants last post by  rogan 
#1 ·
Does anybody know the fixings to fit eh dog guard?

Not the plastic bits that go on the headlining that you get a s a kit but the bits that are on the guard itself that fasten into the brackets in the headlining
 
#6 ·
rogan said:
I had the same problem. Ended up drilling the female nut out and filling the hole with f/glass resin. Then drilled a new hole completely through the bracket, dremelled a flat bit at the back and fitted a T-nut. Strong as an ox and looks ok.
Can you post up a pic of that setup?
 
#8 ·
rrtoadhall said:
Can you post up a pic of that setup?
I didn't take any pics when I was doing it, and you can only see the difference when you unbolt the bracket from the roof. I don't particularly want to take them out. With guard in place they look completely stock; with guard off the difference isn't really noticeable unless you're looking for it.

If I take them out in the near future I'll try and remember to take some pics.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top