[Dbrinkmann]

Does anyone know the part number of this pin that holds the dog guard to the ceiling mount?

 

[Dbrinkmann]

This is exactly the info I needed. I'll measure the existing one and see if I can find a comparable southco part, looks like I'll have to order a few. Headed out on vacation for a week so it might be a bit before I get this sorted but I'll post back here. @rrtoadhall, it's not snapped off, maybe just a bad photo.

 

[Dbrinkmann]

finally had some time to spend on this. got out the micrometer and measured the one that i had. it would appear to be a Southco 82-12-260-20 or 82-12-260-16 depending on whether you want it in stainless. Going to order some later tonight, will post back on the fit once i receive them.

 

[Dbrinkmann]

yeah no idea, i might take a look at the local ace hardware to see if they have anything. I ordered a few extra dzus fasteners just in case

 

[Dbrinkmann]

There were 2 plastic washers on the one that I had so I split it up and didn't need to hunt it down at ace hardware. I can also confirm that the part number Southco 82-12-260-20 or 82-12-260-16 depending on whether you want it in stainless is the correct one. Hope that helps someone else down the road. My dog guard is installed!

 

[Dbrinkmann]

No minimum, direct from southco