Range Rovers Forum banner
1 - 2 of 2 Posts

·
Registered
1970-1995 Range Rover Classic
Joined
·
32 Posts
Discussion Starter · #1 ·
Dies when shifting into reverse and etremely low idle in 1st.... 96 4.0 SE

So all was well for a bit and now... To start I removed IACV and cleaned with carb cleaner. Installed clean IACV and checked TPS for signs of wear but it looks brand new. Looked at MAF and it's clean. Started the vehicle and all was well again, or so I thought. This morning I started the rover and shifted to reverse... dead. Restarted and shifted to first and again low idle. Put into reverse and dead.... The same problem but now a cheap scanner picked up a generic code, P0743 torque converter clutch solenoid circuit electrical. Anyone have this problem pop up for them? I have searched but nothing posted has been quite like this one. Frustrated Thanks guys
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top