RangeRovers.net Forum banner

1 - 3 of 3 Posts

·
Registered
1995-2002 Range Rover P38A
Joined
·
33 Posts
Discussion Starter #1
Just looking for a bit of advice - have got the locking nut off of the front of the crankshaft pulley, ready to change the front oil seal, but the pulley doesn't want to follow the nut off. Seems nicely seized on there. Gave it a blast with penetrating lube, but nothing.

Anyone any advice on best way to loosen the little beggar?
 

·
Registered
1995-2002 Range Rover P38A
Joined
·
1,295 Posts
Re: Crankshaft pulley not coming off

2 or 3 legged puller? block of wood and a hammer?
 

·
Registered
1995-2002 Range Rover P38A
Joined
·
33 Posts
Discussion Starter #3 (Edited by Moderator)
Re: Crankshaft pulley not coming off

Got it in the end - got an angle from underneath to tap it cleanly with a rubber mallet.
 
1 - 3 of 3 Posts
Top