RangeRovers.net Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
Hello!
Yesterday I've changed the center bearing of my propshaft (4h all in all) because I had the juddering in the transmission and the rubber of the bearing was not really good anymore.
While doing this i have recognized that the Rzeppa joint near the center beering is moving not really freely. You can bent the joint but then moving back to 0° is not so easy...
(I've cleaned the joint by washing it without disassembling and then reassembled it with adding grease.)
Is this normal?
BTW: Maybe this is the reason why they don't cell the bearing separately...


Gesendet von meinem SGP521 mit Tapatalk
 
1 - 1 of 1 Posts
Top