RangeRovers.net Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
59 Posts
Discussion Starter #1
Getting ready to do some minor and medium body rust repair any info, ideas, help and critique would be helpful. Working on the floor boards,tailgate top and bottom ,back door wheel wells, and Rocker panels and under door frames.I will be documenting as I go with pictures.Any resources or info would be greatly appreciated. Thanks Warren
 

·
Registered
Joined
·
523 Posts
I'm in the middle of a similar job. Just done both rear wheelarches, rear body crossmember, etc, etc. Basically ready to install the new rear floor panel. I have taken lots of pictures, so if you need a steer on anything just shout.

I will get around to posting the pictures at some point.
 

·
Registered
Joined
·
536 Posts
I've got a 95 lse and just about to start this sort of thing also. I've got the rear body cross member, front floor pan and transmission tunnel, both rear doors, all window channels and under the decker pannel below the windscreen on both sides. Yes any photos or info would be greatly appreciated, especially regarding the rear body cross member.
 
1 - 3 of 3 Posts
Top