I got these lights on this brushguard, and after searching on the net with the number on the lense, it looks like they are Hella FF1000. I ordered a wiring harness, but the ends don't match up. Is there a place where I can get a connector, or should I just clip the ends of both and wire them together? If I do that, which colors do I connect? One has black and white, the other black and green, I just assume if I clip I wire the black and black together, and the green and white. Thanks
Get the loom I mentioned in the linked thread - it will get your lights working perfectly, or, show uswhat loom you do have there and I'm sure we can figure out what you need to get them working.
If you have a loom there that is like the one in the linked thread and you want to remain OEM stylie then get the matching female 'Econoseal' connectors and chop off the old connectors and put them on the loom you already have.
So here's the story, have just had all the rocker arms, timing chain, cam followers, camshaft machined, all to get rid of the damned ticking that has plagued my poor rover for months. But now the ticking is back and worse than before the work was done. I don't know what the issue could be, and...
Flat battery and then the bonnet wouldn't open! I found a few ideas on how to pop the catches but not easy to see what you're doing. What I found is that from underneath you can see the centre of the catches and the pin that screws into the bonnet has a big slot in it. With the aid of a long...
I have a 1998 Range Rover 4.6 HSE.
The service engine light is on and I'm wondering if it can be reset.
I've seen posts about resetting it with a paper clip into a box mounted in the kick panel or under passenger seat or holding down trip button.
I looked into the paper clip reset method, but...
I just acquired a low mile 22k 99 green on lightstone p38. It’s great but the front driver’s side and passenger side scuff plate by the door sill are cracked and the license plate light trim is also cracked. The rear E pillar has a slight scuff also. Any chance anyone has any of these parts in...
I need a rebuild kit for my 4HP24 in my 2001 4.6 p38. I need the clutches, steels, gaskets, seals, etc. The whole kit and kaboodle. I just cant seem to find a kit from a source I can trust.
Thanks
Eric
We’re a community forum to discuss and assist on issues with every Range Rover model. Sign up if you have a question, answer or to meet like minded individuals
