Range Rovers Forum banner
1 - 6 of 6 Posts

·
Registered
2006-2009 Range Rover Sport
Joined
·
17 Posts
Discussion Starter · #1 ·
hey again.....

im looking for someone in the denver area (will come to you) that has the software-programmer to help me calibrate the height sensors.. i think there out of spec.

thanks
curtis
 

·
Banned
2006-2009 Range Rover Sport
Joined
·
224 Posts
hey again.....

im looking for someone in the denver area (will come to you) that has the software-programmer to help me calibrate the height sensors.. i think there out of spec.

thanks
curtis
The IIDtool is locked to VINs, so if you found someone with one of those, you would need to buy an extra VIN for $100.
 

·
SUPER MODERATOR
2013 RS, 2017 FFRR
Joined
·
4,515 Posts
Close to the same cost as 1 hour of labor at Land Rover Flatirons...
 

·
Registered
2006-2009 Range Rover Sport
Joined
·
17 Posts
Discussion Starter · #4 ·
Flatirons has always been good to me.

And I agree. I didn't know all the systems all-coma etc were vin locked. I know there are so many out there

Thanks though
 

·
Registered
Joined
·
64 Posts
not trying to jack your thread, anybody know the OEM spec of the calibration? saw it somewhere in the forum post, but couldn't find it now.
 

·
Registered
2006-2009 Range Rover Sport
Joined
·
74 Posts
not trying to jack your thread, anybody know the OEM spec of the calibration? saw it somewhere in the forum post, but couldn't find it now.
466mm front and 485 mm rear (measured from wheel center to lower edge of wheel arch) for MY05-13 Sport.
 
1 - 6 of 6 Posts
Top