Range Rovers Forum banner
1 - 3 of 3 Posts

· Banned
Joined
·
902 Posts
Discussion Starter · #1 ·
I did my drop links today and everything was fine for about 10 miles then i get an adaptive dynamics fault on the 2011 sc after a u turn.

I looked at the wires to shock towers but dont see any breaks. Im afraid this might be related to the install of the drop links
 

· Premium Member
Joined
·
2,471 Posts
Assuming you only replaced the fronts, but it shouldn't be related. Pull the strut top covers and check the wiring a little more.

There is an overlay available with a new connector and the right grommets to go through the cover, not too pricey if I recall.

But wiring issues are the most likely cause of just this fault.
 

· Banned
Joined
·
902 Posts
Discussion Starter · #3 ·
Dave, thanks! I checked again yesterday and the break in wire was under the grommet. I owe you a beer!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top