[jdkohnke]

I had my Traction Failure / ABS Fault diagnosed this morning. The shop said that it is my Right Front ABS Sensor. Testbook is not receiving any signal.

I have read the FAQ about wire repar. Two questions:

1. Do sensors typically "go bad"?
2. If I pull the sensor, is there any way to test / diagnose its function (and hopefully subsequent repair) using a multimeter?


Best regards,

jeff

 

[jdkohnke]

Thank you very much! I am going to pull the sensor tonight.

Can anybody tell me if there is a trick to it, or does it just pull out and push in?

 

[jdkohnke]

The shop said that it had partially worked it's way out. Now that you mention it, that is the one sheet from Testbook that I didn't get a printout of. The tech said that he pushed the sensor down, but wasn't getting any output at all.