Range Rovers Forum banner
1 - 1 of 3 Posts

· Registered
1995-2002 Range Rover P38A
1,851 Posts

Before you start make sure you do not have any pressure left in the system by pressing the brake pedal 30 times without the ignition on. Unscrew the pressure switch after unclipping the wire connection and pulling it out. Screw in new unit make sure the o-ring is in good condition and lubed with oil. Reinstall wiring and bleed brakes as per workshop manual instructions.

Good luck

1 - 1 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.