RangeRovers.net Forum banner

1 - 2 of 2 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter #1
94 3.9 EFI & Transmission in '87 Rangie. Gear selector.....

Hi there, new to this forum so G'day from OZ.
I've put a 3.9 Discovery and tranny in my '87 rangie. I'm finding the gear selector wont select the gear in the right position on the gear lever (Auto).
My wife has the 94 LSE, which has a slightly different spacing on the gear selector, between R & D. Is there anything I can do without having to change the selector unit in the console? I assumed the tranny itself was the same? any ideas? Is the selector arm at the tran end of the cable a different length on the newer unit? Any advice would be great.

cheers, Andyb
 

·
Registered
Joined
·
318 Posts
Re: 94 3.9 EFI & Transmission in '87 Rangie. Gear selector.....

disconect the selector cable from the box then put the box into neutral and the selector into neutral then try to reconnect the cable to the lever bracket on the box if it will not fix then undo the lock nut and turn the pin either way untill the pin fits then retry with the cable attached
 
1 - 2 of 2 Posts
Top