RangeRovers.net Forum banner

1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter #1
So i just put back my motor after head gasket change, set the timing but i think im off a tooth or two, i did set the cylinder 1 a little lower than the tdc(my fault), but i have been reading on some jaguar forums that crank shaft position is cylinder 1 at tdc plus another 45 degrees turn, ps. I dont have any crank shaft tool, any help would be helpful.
 
1 - 1 of 1 Posts
Top