RangeRovers.net Forum banner

wits

  1. Can't retract rear brake pistons

    Range Rover Mark IV / L405
    2014 Range Rover Sport SE v6 3.0L. Long story short, I have both rear calipers off the car and cant for the life of me can't get either piston to retract. These calipers are outfitted with the plastic EPB motors I have tried twisting, using clamps, opened bleeders, and even some weird...
  2. endless battery issues, at wits end

    Range Rover Mark III / L322
    I've had my 2010 Range Rover Supercharged for about two and a half years (bought from Jaguar Land Rover dealership) and have experienced battery/electrical issues ever since (battery is too low to start car). Initially it would happen every 8 to 12 months, but now it happens every couple of...
  3. 3 amigos at wits end in Australia

    Range Rover Mark III / L322
    I have the dreaded 3 amigos ... I have had my wheel speed sensors swapped on front wheels but still end up with "open circuit front right" error had the wiring changed from the wheel sensor to the unit and "voltage" or whatever is measured is ok. Had a new steering angle sensor fitted about 4...
  4. P0308 Misfire Cylinder 8 Code? At wits end trying to diagnose? Any thoughts .....

    Range Rover Mark III / L322
    P0308 Misfire Cylinder 8 Code? At wits end trying to diagnose? Any thoughts ..... Thanks in advance for your help and thoughts. 2004 Range Rover, 4.4 engine, 204,000 miles. Out driving and get the service engine soon blinking light. Read code and get P0308. Shudders at low speed - not as...
  5. P38 EAS problems, at wits end

    Range Rover Mark II / P38
    Hello. I've been having problems with my 1997 4.0 SE P38. It throws 'soft' faults regularly on the suspension, with no relevant issues read with EAS unlock suite. and lately it's been throwing 'hard' faults. I meticulously rebuilt the valve block and compressor, replaced every o-ring with the...
  6. Bouncing Locks still after RF antenna removal.

    Range Rover Mark II / P38
    Hello All: Ok, so first. I know that there are tons of post out there on the this, the latches, the RF unit not being updated, etc and I have probally read every one of them, but I still have questions about this lock problem and hoping someone can help here, or at least point me in the right...
Top