Search Results for ‘voltage’

Hello everyone, I wonder if I could get some help with an electrical issue. I own a 2007 Vogue SE TDV8. I have had it for 3 years. It's my daily driver. Everything on the car works but just recently I have noticed a few of the systems 'locking up'. When the car is left overnight and then...

Gents, I want to replace the voltage regulator of the Rangie, as long as I have her she's charging around 13.7 and 13.8 volts, never had a flat battery, but gearbox fault pops up sometimes, now winter is here it happens more often. A while back I had the alternator off and looked for a part...

1995 Range Rover Classic LWB I am finally down to this code in the process of getting my ABS to work: Code 2-8 - No voltage to ABS solenoid valves. Faulty valve relay or wiring. I currently have the ABS and TC light on. The pump runs for 30 sec, I have power to, two of the three relays on...

Driving along 2006 supercharged, dashboard goes nuts fault warnings and chimes and lights, radio kicks off, then the whole dash lit up, and promptly went dark. Get it home thank god, and find a loose battery terminal. Tightened that, checked all fuses, battery showing 12.7. Start it up, and...

Trying to get my 99 p38 smogged but the smog tech keeps telling me I have a ?Voltage too high? code coming up and won?t touch the vehicle. He won?t give me any specific code numbers so I can look it up and I can?t seem to find anything about this around the forums I?m a member of. Anyone had...

In additon to my axle issue I am have an EAS issue. I have been getting an "inactive" message. I usually use my icarsoft reader to reset it. Now I a getting a CAN BUS fault. When I hook the reader up it is able to clear the fault and restore the lights on the dash, but not the operation...

ive got 2000 range rover 4.0 and i have 2 codes 6c "permanent voltage supply fault" , and 70 or P0340 camshaft sensor fault , i can drive but around 30 miles/h start shaking , anyone can say what to do ?

I have a 2004 Range Rover with 110,000 mi. I started my O2 sensor saga with a code stating the O2 sensor was not heating properly. I believe at the time it was the B2S2 sensor and identified it as the left side rear sensor. I was unable to remove it and took it to my indy who encountered the...

Hello everyone, I have a 2006 RR HSE Supercharged. Recently, I had an error message "Suspension fault. Car uneven when turning to corner" or something similar. I took the car to the dealer. They told me they are getting C1B14-C error message, indicating bad sensor on rare driver side. They...

'99 4.6 HSE 138k miles The wife drove the RR to work a few days ago. She says it did crank slowly when she left but started. Would not turn over at the end of the day. Attempted to jump start but still would not turn over. Voltage is good, 12.5V on a couple month old Interstate. All...

Seeking advise on what I should read or check next. Our 2001 P38 started giving faults such as gearbox failure, etc and started running erratically. The engine the cut out and it would not start. It was towed home. About 4 hours later it started. I measured voltage across battery terminal as...

Hi I recently upgraded my nanocom and started using the live capture feature One thing which stuck out was that my battery voltage seems all over the place! I have a voltmeter in my dash and it is fine, so is the screen reading on the nanocom. I have attached graph and I wondered if anyone...

Hi, After checking my Faults by IIDtool i got the following error code: C1B18-62 (6C) Supply voltage x-ref check After starting the engine of my RR td6 if have the message "SUSPENSION FAULT" on my dashboard. Can anybody help, I'm a real newbie an are just owning my RR for 6 weeks? Here the...

2010 RRS here. After having some problems with my previous battery, I've been obsessively monitoring the voltage on my car with a multimeter before and after most drives. After I had initially put in the new battery, the idle voltage before the drive and after was healthily (is that a word? It...

Hi All, Beast now circulating gently in Portugal. I must say it is nice not to have the a/c on flat out as it was in Dubai. But, the charge voltage has increased from 14.1 max to 14.2V. No, it is not my imagination. Ambient is low to mid 20s C instead of 35 to 45 ....

Still can't get my 1990 classic to start. New Battery and switched out three new starter relays all the same. Voltage is as follows: Ignition Off: If I jump pin30 and pin87 engine turns over pin 30 Brown wire 12.50 volts pin 87 Brown-red wire 0 volts pin85 White with red wrapping wire 0 volts...

Hi, Couple of years ago i changed all my cabin lights to LEDs. At that point i noticed that my trunk light always stayed on, rather dim ly. I said i would check it out, but never did. Since i have been having starting problems on and off for about an year i ve been scrutinizing the electrical...

Hello and thanks to everyone in advance if you are able to offer some insight to help me out. My issue(s) started when I went outside a few weeks ago to leave for work and put key in the ignition turned it over and nothing, no crank, nothing. I went inside got my all comms and laptop and began...

I think my battery failed last night, I'm about to test it today thoroughly. I had been out and about all day no problems just about go home and the beast would not start, a quick link up to a slave vehicle, and away we went, the short return journey gave some worrying issues, occasional...

so I just installed a brand new Bosch alternator. I am still getting fluctuations in power. You could notice this on the dash and interior lights.I had changed the alternator initially because it was making my light bulbs go out on occasion. What could be the culprit of the power fluctuation...