RangeRovers.net Forum banner

valve

  1. Transmission Valve Body

    Range Rover Mark III / L322
    Hello All, Over the course of the last 2 years my ZF transmission has been giving me issues. Initially, I was noticing a harsh 2-1 downshift when coming to a stop. this went from being intermittent to probably 70% of the time. As time progressed, shifts when decelerating and accelerating...
  2. Source for overhauled valve blocks ?

    Range Rover Mark II / P38
    I know i have seen companies that provides overhauled P38 EAS valve blocks. Mine does not function correct, and to rebuild it with just the o-rings, is meaningless, unless i can get new one-way valves installed at same time. New one can be purcased at Island4x4 for about 650gbp, livable if it...
  3. Power Steering issue resolved - transducer/servotronic valve

    Range Rover Mark III / L322
    Hi, I'm new to this site as a member but have been using it since November 2017 when I purchased a low mileage 2003 Range Rover Vogue 3.0td6 - I love it, and this site! Having benefitted from many postings n this site I thought it was time to give back as success was down to using this site to...
  4. eas valve block wiring problem

    Range Rover Mark II / P38
    Hi Guys. My problem is that my diaphragm solenoid on the valve block is not responding.This is allowing air from the compressor to pulse through the exhaust silencer. I have a pressure gauge teed into the airline from the block to the reservoir /tank. This would not get higher than one 15lb as...
  5. valve cover bolts and grommets

    Range Rover Sport / L320
    Hi I have a 2006 RRS SC. I'm confused about the valve cover bolt grommets. There is a kits that has PART # 4728385 , 4536846 x14 PART # 4728386 , 4536847 x8 PART # 4728387 , 4568726 x2 That makes a total of 24 parts , but its not clear which one goes in which hole ? I didnt keep track when...
  6. PCV Valve Functionality

    Range Rover Sport / L320
    Does the PCV Valve act as a filter keeping oil blow by from going into the intake system? I think on one of my older cars it was just a hose no valve.
  7. Replaced spark plugs and crankcase PCV vent valve

    Range Rover Sport / L320
    Hello all, I just wanted to report back on my installation of new plugs and PCV valve this morning. On a level of difficulty, i'd say it's a 4 out of 10. I say that because you will need a good set of extensions and the ability to work in tight spaces for the driver side rear most spark plug...
  8. Valve and upper timing cases off a few questions

    Range Rover Mark III / L322
    Yesterday I removed the valve covers and upper timing cases exposing the valve train andcam sprockets (Yes- this is a slow process as I have several other projectsgoing on!). I wanted to pause and install the cam blocks as I have already locked the crank shaft at TDC. In the several videos I...
  9. Evoque Breather Valve

    Range Rover Evoque / L538
    Hello guys, need your thoughts on an issue that has been going for about a month now. My car is a RR Evoque 2014 SD4 , and when it went for service (not LR mechanic) my mechanic discovered oil in the air intake advising that the breather valve needed replacing as oil through the air intake...
  10. Installed Lower temp thermostat, 87 deg C vs 105 deg C

    Range Rover Mark III / L322
    In an attempt to bring oil pressure up at idle, I installed a lower temperature thermostat. This is a 2003 Range Rover with the BMW 4.4L, 166k miles. The stock thermostat is 105 deg C, I ordered an 87 deg C. Supposedly, some models/years/climates used 87 deg C stock, and the switch to 105 deg...
  11. Has anyone heard of 2006 4.2 intake valve issue (220,000km)?

    Range Rover Mark III / L322
    Hi guys, Quick question: I am looking at a rough-ish 2006 SC with 220k on. I know the service history, but the shop is telling me that there is an intake valve issue on the early 2006 SC which causes a slight tap on cold start up (similar to a non-oil filled hydraulic tappet sound, I am led to...
  12. zf 6hp26 valve body question related to roll out shift

    Range Rover Mark III / L322
    i have been researching the zf 6hp26 transmission and its 2-1 roll out kick down issue. looks as if it boils down to valve body and or programing issues my 2008 SC with 230k mi has the roll out 2-1 kick down issue every once in awhile. i have been researching the issue and not sure what way to...
  13. Emission control Purge control valve

    Range Rover Sport / L320
    Does anybody know the correct oem part number for the purge control valve? My check engine light is on and I'm getting p0441 code. Thanks
  14. EAS exhaust valve opens several times after engine stop

    Range Rover Mark II / P38
    Hi All I'd like to confirm that what I hear after the engine/ignition is turned off on my RR (Vogue 4.6 MY2000) is normal. In the first audio file the exhaust valve(?) opens 15 times and in the second audio file the exhaust valve(?) opens 10 times. I am assuming it is the exhaust valve as I...
  15. Getting a 6mm air line from the trunk to the valve block.

    Range Rover Mark II / P38
    On my new P38 I am using a ARB compressor as one aspect of "bomb-proofing" my EAS. I plan to use one of their larger compressor and it wont fit where the old one is. Not to mention it will be easier to run a external air tap from the trunk to inflate tires. My question is from the spare wheel...
  16. Battery Disconnected, Front Gets Low! Valve Block For Sure ?

    Range Rover Sport / L320
    Hi, need some help before i spend money in parts 07 RRS HSE 90K miles overnight its lowering 4 corners on his own front normal height to access mode height with the tires very close to fenders, and no suspension errors and goes back to normal height as soon as the car starts If i leave it with...
  17. AJV8 oil leak, valve cover gasket? Timing chain cover?

    Range Rover Mark III / L322
    Hey, Leaking oil on the passenger side of my engine (same side as PCV) and quick inspection looks like it's coming from the valve cover gasket where it meets the timing chain cover. Is this the most likely place the AJV8 leaks oil? If one is leaking, should I change both while I'm at it...
  18. Fumoto oil drain valve

    Range Rover Mark III / L322
    I am looking to change out the oil drain plug to a Fumoto valve with nipple. Does anybody know if Fumoto makes a size that fits the oil pan on a 2006 full size Range Rover with the 4.2 litre supercharged engine? I have tried search but am to finding much info and am tired of cover the...
  19. EAS unusual Valve Block Noises

    Range Rover Mark II / P38
    I made a video of the noises: http://www.youtube.com/watch?v=p9ZX6nVdlgI The exhaust solenoid is acting weird I think. The last noise is the strangest. Other Issues related to EAS are. 1. Truck rear will raise when driving. 2. Whole truck will raise to wade height when driving. 3. Truck will...
  20. Governor valve

    Range Rover Classic
    It has been suggested that what our Rover may be experiencing is a governor valve gone bad. Only shifts out of 1st after 15 mins warm up. Filter has been changed and metal debris was present. Looked high and low for an online video walking this "backyard mechanic" thru locating and...
Top