RangeRovers.net Forum banner

valve

  1. 2-8 No voltage to ABS solenoid valves. Faulty valve relay

    Range Rover Classic
    1995 Range Rover Classic LWB I am finally down to this code in the process of getting my ABS to work: Code 2-8 - No voltage to ABS solenoid valves. Faulty valve relay or wiring. I currently have the ABS and TC light on. The pump runs for 30 sec, I have power to, two of the three relays on...
  2. consistently leaking valve cover gaskets

    Range Rover Mark III / L322
    I have been having trouble with the valve cover gaskets leaking / seeping oil mainly on the driver side valve cover even after replacing them with new gaskets and valve cover nut grommets. I originally used victor reinz gaskets and grommets and after I noticed that the driver side was leaking I...
  3. 2008 RR HSE SPORT 4.4 heater control valve.

    Range Rover Sport / L320
    Can some one telme where is the heater control valve loated. thank you
  4. EAS Valve Block

    Range Rover Mark II / P38
    My P38 is on coils, but I've been toying with the idea of restoring the EAS. I would plan on buying new Arnott GIII bags, and a new compressor, but was wondering if there are any current forum members rebuilding the valve blocks. I know part kits are available but I don't have the time or desire...
  5. Positive Crancase Ventilation (PCV) Valve Internals

    Range Rover Mark III / L322
    What does the inside of a PCV valve for a 4.4L Jag engine look like, or supposed to look like? I bought a new one and installed it last night (because i have a P2096 post cat Bank 1 lean code - which I actually think is really coming from bank 2, and I have 187K miles on the engine) and on...
  6. Question about PCV Valve '12 Sport SC

    Range Rover Sport / L320
    Hey guys, I'm fairly confident I need to replace my PCV valve, and I'm having a hard time tracking down the part number for my model. I'm right at 91k miles, and recently I'm getting some oil smoke on startup. I just had the 90k service performed and didn't notice this until afterwards. Does...
  7. valve springs

    Range Rover Classic
    Got the head back from the machine shop and suspect they may have got it wrong. The valve springs have been installed nonuniform. Some have the tight end of the spring up and others down - THAT CANT BE RIGHT? I'm in my 60's but seem to recall that the tight part of the valve spring should always...
  8. Range Rover 2006 PCV valve.

    New Member Introductions
    Gday people, I would like to say hello from Australia, specifically Western Australia, Tom Price is a mining town 1500 kilometres from Perth. I understand it is around 02:30 am your time. However it will allow people most of the coming day to reply if there is anything of interest to my thread...
  9. EAS valve block NRV question

    Range Rover Mark II / P38
    I’m stumped on this one. I rebuilt my valve block and all was working fine. Then when I added 400 lbs of lumber to my roof rack I had a EAS fault but made it home. It later hard faulted down to the bumpstops. I used my RSW Solutions EAS software and read a RIght Rear valve stuck open. The rear...
  10. PCV valve

    Range Rover Mark III / L322
    Is the PCV valve ( Part No: LKR000040) for the M62 engine valve the same as in the BMW M62 engine ? Thanks, Chris
  11. Chasing p1173 and p1170 codes after pcv valve replacement

    Range Rover Mark III / L322
    2004 range rover hse Last winter my fuel pump went out, and in the process of troubleshooting and trying to start it multiple times in freezing temps, my pcv hoses froze up and cause the issue where white smoke comes out of the exhaust and the engine compartment, oil ran out everywhere. So I...
  12. Expansion valve replacement advice

    Range Rover Mark III / L322
    Hi, I'm having a/c problem with 2006 RRSC. I'm considering ordering compressor, txv, and drier and doing work myself. I looked at rave, but I'm not sure how difficult it is to replace expansion valve. Has anyone done it? How much do you have to disassemble the dash? Thanks in advance for...
  13. Gearbox or valve body issue ?

    Range Rover Mark III / L322
    Hi All. I have a 2002 4.4 L322 with 181k miles. I've owned it for 13k of those miles. It runs LPG. I don't know if it's original box. I've had the trans fluid and filter done 5k miles ago. It has a torque converter issue that makes the rumbling sound and 200rpm fluctuations on constant throttle...
  14. Rear air valve block replacement

    Range Rover Sport / L320
    Symptoms: The rear would sag on both sides when left overnight or for more than a few hours. Compressor would kick on when starting to fill the rear bags with air again and get back to ride level. Possible solution: Rear Valve block leaking. You can either rebuild or just buy a new one. I...
  15. IACV / Stepper Motor / Idle Air Control Valve Cheap

    Range Rover Classic
    In my 1994 RRC I replaced the IACV with a generic Chevy unit a few years ago. It does function, but the distance per step is too far. Meaning it will open the valve on engine shut off, but when it closes it, it happens too fast (each step moves the valve face too much). When cold, not an...
  16. Valve Timing help

    Range Rover Classic
    So... I had my timing chain off and was messing with my cam to check the wear and then realized I screwed up my timing. I cant find anything in the manual (i'm sure it's there, I just cant find it), can anyone point me in the right direction? Thanks
  17. Rebuilding EAS valve block what lube for o ring?

    Range Rover Mark II / P38
    Is there a specific o ring safe lube you would recommend for the EAS valve block rebuild? I have some Finish Line white Teflon lube for bicycles that I think would be safe. I know it needs to be non petroleum based to protect the o rings. What have you guys used? Any particular brand?
  18. Top end is off for a valve job - what else should I replace

    Range Rover Classic
    1995 RRC with 3.9 engine w/ 180k miles I've got my heads off to do new gaskets / valves, springs, and guides. Aside from that I'm wondering what else I should think about replacing while it's all torn apart. The pistons looks crusty but I don't know if that's something to be concerned with. I...
  19. EGR Valve - should valve/piston slide easily when out of car

    Range Rover Mark III / L322
    Hi Not sure if this topic has been covered but i can't find the answer. I have removed my EGR valve from my L322 TDv6 04 to clean as it was really gunked up. Its come up nice and clean but my question is should the piston/valve move easily when not in the car. I have tried to move with my...
  20. Replacing PCV Valve on 2010 Rover Sport Supercharged

    Range Rover Sport / L320
    1st post on the site. My 2010 Rover Sport Supercharged began making a high pitched horn-sounding noise from the engine. The noise has gotten louder. It's louder when the car is warm. It's very loud for about 2-3 seconds after the engine is cut then quiet obviously. I have an aftermarket...
Top