RangeRovers.net Forum banner

valve block

  1. EAS unknown fault

    Range Rover Mark II / P38
    Hello. Yesterday I had normal eas system but I used to buy a new valves #2 and #3. After installing right front airbag didn't want to pump. I installed old valves but now suspension doesn't want to pump it all. Looks like valves don't want to open. I removed second valve and noticed that air...
  2. The saga continues... My EAS has stumped me again.

    Range Rover Mark II / P38
    Hey everyone, Let me provide you with a brief history of my EAS: Hard Fault, 400 mile drive Clear faults replace valve block O rings Still slow leakdown overnight Hard fault, another 400 mile drive (realizing I'm an idiot for waiting) replace rear air springs, car does not pump up replace...
  3. Air suspension randomly drops to bump stops RRSC 2007

    Range Rover Mark III / L322
    Hi! I'm having some trouble with my RR SC 2007 air suspension. When left for night sometimes it drops to bump stops, sometimes it doesn't. When disconnected from battery it can stays raised for weeks. Already checked for leaks at front valve block and air compressor, but couldn't find any. Also...
  4. EAS Valve Block controller

    Range Rover Mark II / P38
    Has anyone had their Valve block controller go bad? The controller that bolts to the side of the valve block. I have searched this forum an I have found very little. The local shop here in Seattle wants to replace it on My 1998 P38. The truck is throwing lots of codes: 0 : FL signal...
  5. Valve block/Compressor refurbished - Scotty comes through... again!

    Range Rover Mark II / P38
    Valve block/Compressor refurbished - Scotty comes through... again! Thanks goes out to Scotty (SoCalUsedRoverParts: https://www.socalusedroverparts.com/), for sending me the valve block o-ring rebuild kit and compressor rebuild kit for my EAS. He sent them very quickly and I was able to rebuild...
  6. P38 Valve Block Diaphram/Orange disc replacement

    Range Rover Mark II / P38
    I'm doing my 2nd valve block rebuild and have a question. I noticed on my 1st rebuild, after installation of the diaphram with the orange disc, when my system lowers that there is now a noise from the valve block that was not there prior to the swap of the diaphram to the disc. Is this normal? I...
  7. EAS Hard Fault! Uh OH!!!

    Range Rover Mark II / P38
    My rangie went into hard fault Thanksgiving day on my way back from dinner (awesome!) So naturally I sent in my EAS ECU into get it reset. I also rebuilt my Valve block and Air compressor. Here is my problem. The commutator brushes in the "endbell" of the compressor are shot and I need new...
Top