test

Hello All! Anyone have a link or a view on what the Land Rover Rang Rover SC crash test rating results are? Or where I can find these results? I know the NHSTA did'nt conduct a test.... not sure why.... Did some searching here and via google - no luck. TIA!

Hi all, Glad to join the clubhouse

Distributor died and needed replacing. Anyone know if one can test its pickup with a meter and how? Thanks.

Hello Forum I have been searching off and on for almost a week now and have not found a place on this engine to perform a fuel pressure test. It does not have a schraeder valve and I believe the fuel filter and pump are in the fuel tank. There is a line that connects the two fuel rails and I’ve...

Hi All, I have trick to pass inspection testing even if you get p420 errors. I don’t know if this will work on all vehicles or just range rovers or just my vehicle . I have a 2006 Range Rover Sport SC 4.2 with 150k miles I have been using this trick for 2 years now to pass inspection tests. I...

got into the diagnostic screen and start the self test for codes and it times out. no codes presented. is this a problem or does it mean there are no codes present?

Hi, Red Battery Light Symbol is showing on my dash. Battery is draining, and I could smell something under hood that I associate with burning electronics smell. I assumed this was a bad alternator after reading multiple posts on this forum. I removed the alternator and took it to autozone...

anyone out there know what the readings are on a good and bad coil. i have a extra set of coils and have been swapping coils for over a week and still cant shake the multiple misfire codes.i set my ohm meter at 200 ohm and all the coils read .8 at each terminals on the outer ends but when i...

Any one now which wires to test on TCM if soleinds or ok in gear box thanks

I have a Range Rover L322 (2007) and both the red and amber brake symbols on the dashboard are not lighting up as it should when the ignition started as a bulb test. Would anybody know what it can be? Best regards.

I am still troubleshooting my transmission's lack of an output shaft speed signal, and one of the things that I have come across a couple of times is how important the screen on this cable is. Output Shaft Speed Sensor –pins 2, 38, 20 The automatic gearbox system incorporates an output shaft...

I bought a new part # STC1184 ignition amplifier from Amazon for my ’93 LWB, and just verified via RovahFarm.com that this is the correct #. They sell the same part #.I installed it and the truck wouldn’t even fire. Swapped back to my suspected bad amplifier, and the truck started and ran again...

Hi I have still not managed to solve the problems on my three cars - I have RAVE and I've read the stickies, following a wiring diagram is not easy 1. The 96 model I can live with, it won't swing when I turn the key There is no earth/negative power on the relay pin 85 on the fusebox for...

Hey guys, I read that vacuuming removes more than the old-school drain method, but according to my little test last night, that wasn't exactly true. I think that I did everything per LR procedure, but feel free to chime in if you disagree: - warmed up the oil by running the truck for 10 mins...

Does anyone know of an app for weather radar, I have the AccuWeather app loaded but only see basic temp & wind info. Also, my favorite internet speed test from OOKLA does not seem to work, any recommendations?

I've recently completed a P38 complete rebuild and I'm trying to get it to pass the California Smog test. My scanner shows the heated oxygen sensors not ready, and the evaporative system not ready, and I can't get them to change over. What I know: Drive cycles properly completed as well as 250...

I'm looking forward to working on my truck to keep maintenance up to spec, and learning from this very substantial community. I once bought a worn D1 and made it quite trail worthy. I pretty much keep my P38 as a daily driver, ready to explore the coastal back roads, as well as the Sierra...

Hello everyone, I have a 1998 4.6. I was attempting to get the car registered and a moving permit here in NV, but I am having issues passing the smog check. I took it to a smog place who said that I had a previous pass on file, when we reran it, it failed with a P1313 code (related to gas in the...

pretty impressive: https://www.autocar.co.uk/car-news/new-cars/range-rover-velar-scores-five-star-euro-ncap-rating

Hi, Ive got the problem when i try to take my RRS to the brake dyno it blocked the brakes when i try the brakes. Ive tried to disconnect ESP but it will not help. Should i remove the relay for the ABS?