swap

So my old bus gets the occasional lean (1995 p38 with STC rear sensors) - when it happens its always low on the left side at standard height by about 20mm front and rear. Reading nanocom there are no faults, but I consistently get the front sensors both reading at around 148 (the configured...

Hello Folks! I am brand new to this board, although I have been doing a lot of trolling over it the last couple of weeks. Lots of good info. I also have a similar post on a Jaguar motor forum. I have a 2012 RR 5.0 with an AJ 133 engine that overheated so badly that the motor needed...

Hello Folks! I am brand new to this board, although I have been doing a lot of trolling over it the last couple of weeks. Lots of good info. I have also posted this same question on a jaguar forum, so I apologize if maybe you see this on a different board. I have a 2012 RR 5.0 with an AJ...

I think a few know me from my former SDV6 Hybrid and actual P400e Plug-in-Hybrid, as a new technology fan. As I am on the other hand also a car guy, both worlds colliding here for me. Shortly, I change my P400e into a P525... Why: The P400e is a great car and does everything exactly as it...

hello, i recently purchased a 2008 Range Rover HSE with a bad 4.4i engine. Can i swap out the engine for the 4.2 supercharged one from the same year? thanks, DoN

Hi, Has anyone done a R380 or LT77 swap in a classic before? I'm considering it, and would appreciate the resource. I know that the '95 came with a manual option from the factory, but don't think it was available in NAS. A parts-only discovery with a manual box popped up on craigslist, but I...

I am wanting to do away with the typical P38 issues and do a complete swap to a mechanical set up. Either 5.3/6.0 Chevy or a 302/351 ford with there usual 4x4 transmissions. I know they will not work with the factory front and back rearends so those will have to be swapped as well...

I am trying to determine the viability of putting the more reliable 4.2 supercharged engine into a 5.0 2012 RR AB. You would have all the upgrades of the 2010+MY but without the troublesome engine. You would have to add the associated transmission as well for the 4.2 engine. Has anyone tried...

Anyone know if it is possible to replace a 2007 RR 4.2SC with a 2009 Jaguar XF 4.2SC. If so, what are the differences as far as components?

Hi everyone. I'm sure this has been covered, and if someone can point me to the right thread that would be great, but I swapped out the old light bulbs for the interior with LED style bulbs. Everything worked great up to the front doors. The lights at the bottom of the door, I think they're...

Good morning folks: I placing this out for thoughts, not to offend the purists, but to be practical. As my RR grows older I am sure that things will eventually start to fail despite my OCD preventive maintenance, that been said I have seen throughout my life dealing with cars that all kinds of...

I changed the fuel pump on my '93 LWB, but the old pump had a ground lead from the vehicle harness that plugged in to the top, while my new pump has NO place for a ground lead. It came with a harness jumper from the vehicle plug to the pump, so this groundlead is just laying there with no place...

Hi, Usualy I'm in the P38 section, but now I'd like to try my luck here.. ;) I've got a P38 (4.6 HSE) and a Disco 1 (V8 ), someone did me an offer I couldn't refuse, a 4.6 GEMS for $500, so I bought it to put in my Disco, it's in and it's running. Problem is, it's idling way to high, I put the...

Hi All Excited to get the new to me Range Rover Classic on the road. I just picked up a 1990 Rover County It had been sitting in a neighbors yard for a few years. Her husband worked on it and then passed away. She gave it to me to do what I want. I went through the vehicle, cleaned it up as...

On a 2003 RR, with M62 engine. I did a full engine swap from a BMW 540. After the engine swap. my fuel pump wasn't turning on. After an investigation, I concluded it the wire from the glove box to the relay to signal the relay to turn on. However, to bypass any fuel pump issues, I just jump...

Recently Broke the Ring Gear on my 1995 County LWB which put a hole in the axle housing. Haven't had any luck tracking down a 95 RRC rear axle assembly near me but have found a few Discovery ones. Does anyone know if they will bolt up to the Range Rover mounts? The Discovery is a 1996 series 1...

Digital tv no picture... Hi all, just fitted to my RR Vogue se 2006 1 x RANGE ROVER L322 - LEAR HYBRID TV TUNER - LR014222 - 7H42 19C063 AB (Brand new unused unit) to replace the analogue unit, we now have digital channels & sound but no screen display. Read somewhere that the head unit has to...

Searched but did not find anything definitive. Seeing as it's not possible to get a new remote anymore, is it possible to swap the physical key and the innards into a new casing that I have access to, and if so, anyone know if there is a write-up floating around? Thank you.

Does anyone know what the time is to swap the engine in a 06 super charged rover?

I am doing the engine swap soon, just wonder if anyone had any good resources/manuals for this I found this one online, however, it doesnt show anything on engine removals http://www.landroverweb.com/Pdf-files/Manuals/Workshop%20Manual%20L322%20Range%20Rover.pdf