RangeRovers.net Forum banner

support

  1. Suspension fault when cornering Range Rover support 2009

    Range Rover Mark III / L322
    I have some problems with my range Rover sport I have change the steering angle brand-new plus the compressor but the problem is still there. All the cables and the wiring has been checked there is no issue been found I don’t really know what I really appreciate it if someone had same...
  2. Seat lumbar and bolster support

    Range Rover Sport / L320
    Hi, Both the adjustable lumbar and bolster supports in the driver seat of my 2012 RRS inflate fine, but then deflate (i.e. leak air somehow) to flat again over about 15 seconds. Anyone have any ideas what the problem might be and if it is expensive to fix? The seat is in good condition with no...
  3. Problems with "New to Me" RRS - Advice/Moral Support?

    Range Rover Sport / L320
    Problems with "New to Me" RRS - Advice/Moral Support? Hey guys, First time poster, first time LR owner. I've been lurking these forums for the past two months as I was deciding which vehicle to buy, and now for all the issues I've been dealing with. Bought a 2013 RRS SC Limited Edition at the...
  4. Parcel Tray Support - What am I missing?

    Range Rover Classic
    Trying to figure out how the hanging carpet attaches to the parcel tray support, and well, it's not obvious. And it doesn't look like I'm missing any parts. Yes, my support is in bad shape, cracked, worn, and missing a peg (already ordered). But I don't see any evidence of a clamping bracket...
  5. Cross member removal/trans support question

    Range Rover Mark II / P38
    Need to replace my exhaust system from front to back and obviously the cross member needs to come out. Where's the best place to support the transmission. Am I ok just placing the floor jack under the pan?
  6. **UPDATE FROM SUPPORT** issues on Vbulletin 4 software

    General Chatter
    We’re currently experiencing multiple reported issues on our sites running on Vbulletin 4 software. Our techs are currently looking into the issue to find a solution. While we look into a fix you may experience some of the following issues: Unable to use reply to thread Unable to edit posts...
  7. Lumbar support won't inflate, fan runs.

    Range Rover Mark III / L322
    On my 2011 sc the lumbar support on the drivers side won't inflate. The compressor runs. I figure I got to get to the bladder without hurting seats and find the replacement bladder part number. Any help would be appreciated, thanks!
  8. Rear "End Fit" Support

    Range Rover Classic
    Hey Gang, I almost certain that this part is extinct and for the lack of any Classics at the breakers around here I will most likely have to fab on up. Any suggestions or tips on replacing the End Fit body support that houses the rear wiper/squirter ? For one side is terribly rotted. Not my...
  9. Need help finding a part number for support pieces in the engine bay

    Range Rover Mark III / L322
    Need help finding a part number for support pieces in the engine bay The parts numbers I'm looking for are the plastic pieces that separate the engine from the battery on the passenger side and the brake reservoir from the engine on the driver's side of the front--the two pieces act as a...
  10. Range Rover 05 audio support

    Range Rover Mark III / L322
    Hi all, First time I have been on the site as yesterday I have just purchased my 1st Range Rover. Anyway I am looking for some advice if possible regarding a few things and possible options. I would love to play my music and connect my iphone 5 through the speakers. Even with the...
  11. Rear Bumper Support Bracket Clip & Suspension Air Reservoir Queries

    Range Rover Mark II / P38
    Rear Bumper Support Bracket Clip & Suspension Air Reservoir Queries The rear bumper side support brackets and clips on my model year 2000 HSE 4.0 are pretty much completely rusted away. Can see some little stubs of clip in the nylon carriers on the bumper but no sign of the brackets except for...
  12. Removal of Parcel Shelf Support Trim

    Range Rover Mark III / L322
    Hello folks, now being bald due to pulling my hair out trying to find the answer before posting I have bitten the bullet... Has anyone ever taken the plastic trim that supports the parcel shelf off a vehicle (2004 model) please? I have taken off all the obvious screws and bolts yet still there...
  13. Chassis support necessary when depressurizing?

    Range Rover Mark II / P38
    Hello! I have a -98 RR p38 4.6 HSE. I'm about to renovate my valve block and compressor with a renovation kit from symlise on ebay. The EAS is working ok but it is sometimes slow to rise in the mornings when I want to raise it from standard to extended height for example. I find the renovation...
  14. Motor Cutting Out? Check your Hood Support Rod.....No Kidding

    Range Rover Classic
    Motor Cutting Out? Check your Hood Support Rod.....No Kidding This is a first (for me any who, and i've had 4 classics) So we had gone through and replaced all the suspect items that cause a motor to suddenly cut out, Alternator, MAF, Ignition Mod, TPS, cleaned all the ground points...
  15. Why no Tapatalk support?

    General Chatter
    I have the tapatalk app on my iPhone, if I am not mistaken, this forum is powered by vBulletin, why is it not on tapatalk? I've tried searching for it, and it doesn't show up.
Top