Hi again all I purchased a 1985 3.5L RR classic and on start up, I pull the manual choke for a while then I disengage it and she purrs beautifully, revs well. However when I put it under load and though the gears, it struggles and I have to pull the choke hard again. It has little power without...

Hi guys, About a month and 1,000 miles ago I got a P0430 code so I decided to put in some BG44K and clear the code with my code reader. The code has not returned but I have been getting an intermittent rough idle, especially with the AC on. It has happened about 4 times now and it feels like...

Hello. I am the proud owner of two RRS my 2008 I have owned for 5 years. Recently when I start the truck after sitting 8 hours or so, it rolls over good, however it almost seems to want to stall. Touch wood it hasn't yet. Once it rolls over and does this it kicks into fast idle and away we...

Hello Roverphlles, I am no stranger to these vehicles, love them and have been using them since 1990. This issue has me puzzled, on my 95' Classic LWB with 4.2L I am experiencing a strange issue that I need to share with the forum. The weather has turned colder, the unit starts up fine...

Over the past two months my LWB has stalled twice. Once at a stop light and once slowing for a turn. To me this seems like the IACV or TPS, but in both instances there were no OBD codes or even a CEL. Shouldn't something like this trip a code? The CEL illuminates at the start-up bulb test, and...

Hi all, sorry if this comes off as obvious and stupid , but 've been having a recent issue with my Rover stalling on me when warm. I'll be driving down the road and it starts backfiring and then will soon shut off and just crank. So my question is is it the catalytic converter. I feel as if this...

Hi Everyone, I just bought my first Range Rover Classic a couple of weeks ago. It's a 1994 model year, short wheelbase, 3.9l EFI. I'm sure it is a well worn example at 213k miles, but so far I've been enjoying it very much. I've attached a picture of it :) I went off-roading yesterday for...

So it started a couple days ago. It first maybe felt like water in the gas now it got worse to where it stutters and almost wants to die. It has no get up and go. It shakes while stuttering. The service light began to flash. I did the seafoam thing first just in cause but obviously that was...

95 RRC, Driving about 60mph & got cut off & had to hit my brakes hard enough to lock my brakes up just alittle bit nothing to dramatic. My engine stalled & I had to pull over put it in park, turn the ignition off then restart. My diagnostic showed a Gearbox failure for about 25-30 miles then...

2011 RRS SC engine dies when slowing down or accelerating from a stop Hey guys wanted to post this issue I'm having to see if any of the experts heard of this and also to thank you for having such an awesome forum that showed me a TSB to fix a previous issue that the dealer said was "normal...

Reman Engine/New Other: Part (to Full) Stall at 1100 to 1400 RPM okay, this is perplexing me. I have a remanned engine, new distributor, all new electronics (no bleeds, strong ohms / current), MAFS that is new, and even tested other ECMs to make sure it was not the problem and the engine just...

I have a new issue and couldn't find a search result. When I start my 2008 HSE, the tach dips to 1 or below and almost stalls out but then regains normal operating behavior. This occasionally happens when stopping at a light too. I have used 91 and 93 gas and it still does it. Any thoughts...

Hi Yesterday I tried starting the car and it fired up for a second then it stalls It had been a cold night and this was in the morning. It will eventually start but I have to rev a little otherwise it will stall again at idle, Once the car is warmed up it starts fine and has been fine all...

Hi all.... My HEVAC ECU is reporting this and as with most P38 fault codes, I have accepted that a literal reading of the fault message is most likely to NOT be the actual problem faced. Now.... I've had a few different fault codes before but never this one. Can anybody tell me what the most...

Hello! After a stall at normal driving conditions, I got a code 69. I was driving with the tranny on DRIVE. Engine could be restarted right away and fault was cleared after reseting the ECU. Has this happened to anybody? Is it possible that a faulty contact at the gearswitch could cut...

Hi, What exactly is the meaning of 'stall speed' of a auto tranny? and what is the stall speed of ZF 4HP22 ? Just curious, you know............ regds