hi,thanks for looking. i need some info on the crank sensor, is the tip meant to be 1mm away from the reluctor ring teeth,i know it sits in between the reluctor ring teeth,mine seems to be or is to a depth of about 3- 5mm in between the two teeth,looking through cover plate,i hope i have...

Does anybody know if the late 3.9 motor with the serpentine accessory belt and crank-driven oil pump still needs a spacer to use the 3.9 pulley on the 4.6 crank? I know the earlier v-belt equipped 3.9s have the shorter crank 'snout' necessitating the use of the spacer, but I'm sure I've read...

1999 P38 Off-Road Upgrade Guide Hey, just bought my first Rover about three months ago - after a rebuilding the engine, it's about time I start upgrading for off-roading. I have put about 2,000 miles on the engine since the rebuild, so I know it's running strong. The car is basically stock...

Hello all, I am looking to have 50 mm air spring spacers fabricated for my p38. I need to know what the measurement on size and exact shape is for the d shaped hole that they will need to have in them. i have been reading on paulp38 lift guide and that is the only dimension i really need. i can...

Hi all! Been lurking for years and just recently have been trying to do some stuff to my long ignored 87 Classic swb. Has anyone has any experience with the terrafirma 30 mm wheel spacers? I bought a set from AB and their website plus terrafirma's lists these as fitting my year vehicle but I...

Brake Modulator R&R Stainless spacer repair Russell's Kit I am a worrier. Every time I drive my P38 I think "is this the time the brakes are going to fail?" I love the rig, it has 162K miles, engine is decent, no rust, interior good. I want to keep it, but I'm sick of worrying about the...

Please Help - Engine Swap in progress - Where does this Spacer go I am in progress with a 4.6 engine swap into my P38. When removing the old engine a small spacer about 20mm dia, 6mm thick with an internal hole 10mm fell out as the engine parted with the gearbox. However I cannot find any...

Ok, so i have a VERY slight crack on the back side of my 22" O.Z. wheel, is it ok to have this fixed somehow? My next question is, i found a set of KMC Slide wheels BRAND new with BRAND new tires for $1000, but they are wrong bolt pattern. Is there a such thing as a reliable safe spacer to use...

Hello to one and all, Fairly new to the form but have read a lot of topics on lifted p38,including the recent one about lifting one on springs with blocks, My question is has anyone lifted a p38 on factory air bags with spacers/blocks about 2 inches ? And had good success after a number of...

Arnott springs with Arnott 2" spacer- need installation tips I am giving my P38 to my son for his 16th. It has been converted to Arnott springs, it is sitting pretty much standard right now. Has anybody installed the arnott spring blocks. Arnott was out of 2" blocks and are sending me 4 1"...

Hi , does anyone know where I can get the plastic spacer that fits over the select lever and goes between the gate at the top of the transmission many thanks

10mm spacer in the rear? Anyone? I have the Redbourne nottingham I am thinking of running a 10mm spacer in the rear to give a more staggered look. If Im not mistaken offset is 32. So rear would be 22, would I be worried about rubbing? I run 35cm drop on ALL.