Search Results for ‘serpentine’

Hello, I have a quick question on 2007 L322 naturally aspirated 4.4 serpentine and fan belts - what number of ribs I should use on the main belt? It seems bando usa recommend 6PK2275 as main belt and 8PK850 as fan belt, but on amazon it says that 7PK2275 should also fit. Is it better to use...

Hello Group, Well the honeymoon is over had the truck for a few weeks and the check engine light came on yesterday, notice some strange noises from underhood and a quick investigation reveals the belt/s have disintegrated!! I picked up replacements for both belt today at the dealer, other than...

Good morning folks: Two days ago I heard a weird noise coming from the engine, as I continue driving it came back and go, if I accelerated it will get louder, the end result was that the car overheated, pulled over immediately when the gauge went up and realized the broken serpentine belt...

Hey guys, I have a couple of questions about upgrading my 94 RRC to run a serpentine belt setup. By some twist of fate, I have access to two D1s that have intermediate 3.9 engines (Pick n' Pull). They have distributors and serpentine belts. My plan was to pull the cover, mounting brackets, and...

...does someone have a diagram of how to route this thing.

Following my overheating spell last weekend (bum thermostat - emergency roadside fix was to attack it with a screwdriver and hammer until it was permanently stuck open) I noticed the serp belt exhibited a strange wear pattern. The outside edge (closest to the radiator) on the top (smooth) side...

Possible engine damage. Coolant system, water pump, viscous fan, serpentine belt fail Hi everyone, I think I have really goofed. I was taking my 98 P38 HSE on a long road trip (she always loves to break down on the long trips far away from home) and I started hearing a strange whining noise...

Head Gasket; Serpentine belt. OK where did you put them? and what first? Hello, New P38 vintage 2000 owner here. Vintage 2000 is the car not me :) Start with the main question, I went to the common issues section on the site home page looking for info on: Head Gasket Leak Repair Serpentine...

Seems like things are starting to need replacing all at once. I have a misfire on 3, pretty sure it's the ignition coil but can't check because now my Rover won't start. Went to drive home from a friends Saturday evening and there was a loud squeal coming from under the hood. Got home and...

Does anyone have access to the new generation of RAVE (web based). If so would you mind posting the belt routing and serpentine belt replacement section for the '08 Full Size Supercharged? Would be much appreciated.

Haven't been on here in ages, and I forgot my old account info. So what a better way to start off a new account with issue help. Vehicle: '04 L322, ~96,000mi. Anyway, here is the scenario. I was doing some heavy turning (lots of bump stop to bump stop turning at idle RPMs) trying to back in...

I took it upon myself to replace the serpentine belts on my 2006 Range Rover HSE 4.4L V8. Only thing is that after removing the belt I didn't pay attention to the routing. There for I'm lost to the correct routing. I found some diagrams and tried it but my engine temp overheat. I didn't have...

Hey everyone, I am looking at a 2004 L322 with 130k miles and a broken serpentine belt. The seller claims it was broken due to a seized up alternator. He is selling the car as-is. Any idea what this repair might entail? How much could it cost me? Should the car start with the belt broken? Any...

hi guys. First real problem reared its ugly head this morning. just left work to go home, 4-5 minutes up the road and i lost my power steering and alternator warning light came on. Obvious thought was serpentine belt had snapped. Drove car 200 yards further up the road and tried to manouver into...

Whilst passing the time last week generally searching the forum looking up some general maintenance threads I read some about the drive/serpentine belt. Some threads did mention that the belt shouldn't have any more than 10 splits per inch so checked mine and it had easily double that amount...

Any of you high mileage guys and/or Dave, does the non-S/C serp belt really last 150K? I've always replaced them ~100K in other vehicles but I'm willing to give this a try to 150K if LR says its possible per the maint. schedule. Also I'm assuming you replace the tensioner along with the belt...

Replacing the serpentine belt and accesory belt on my 2006 RR Need some help with how to remove the fan shroud. On my previous Range Rovers, I would just remove the shroud and fan with my fan clutch tools, but the shroud on my 2006 goes all the way around the fan as one piece, and there is a AC...

Range Rover P38. 2001, 84k miles. A "whine" developed again in the area of my serpentine belt. I had similiar sound in 2009/10 and solved by changing cooling water pump. It re-appeared a few months ago and I have been struggling to identify cause. A key sympton is that it is not noticeable in...

I've read all the threads on this bloody job and decided to replace my afore mentioned belt -- I've had to abandon for the night - defeated -- I have it routed around all the cogs -- Grooves to grooves shiny to shiny - dust to dust :) I've increased the fulcrum of my socket handle by...

I need to replace the serpentine belt on my '01 RR and I found this diagram online. The old belt is off...as it broke off on the way home (just spent about an hour unraveling the broken pieces from around the fan). A few questions: 1. Now that the old belt is off, do I need to worry about the...