RangeRovers.net Forum banner

sender

  1. Old sender New sender

    Range Rover Mark II / P38
    Hope I get this right First Post Hello Chaps I have a strange issue with my Thor engine temperature sender.It goes like this:- I decided to replace my temperature sender simply because one of the side clips had broken off. With the new sender fitted I got a very low (in the blue), reading...
  2. Temp Gauge sender

    Range Rover Classic
    My temp gauge has stopped working. Not sure whether its the gauge or the sender... or the thermostat is broken? My guess is the temp sender Anybody now the resistance range that I should be able to measure on the sender?
  3. Replacing fuel level sender

    Range Rover Classic
    Hi I have a seam leak in my 1988 classic fuel tank, have found a good used tank, cheaper than fixing old one The old tank has been removed, I have them side by side The fuel pump is screwed down and seems simple to remove Questions that I cannot seem to get answers for - in workshop manual...
  4. Full tank only shows 3/4 after remote sender & fuel pump rep

    Range Rover Mark III / L322
    Full tank only shows 3/4 after remote sender & fuel pump rep I have access to a T4 with the correct CD's for my 2003 Range Rover BMW 4.4L. I am the owner of the truck and spent an hour today with the T4 system trying to find the area where you "recalibrate the fuel senders/gauge/instrument...
  5. engine temp sender help

    Range Rover Mark II / P38
    Right temp sender reading -40 on live data, changed sensor 3 times now and dicided it must be somthing else so have cheacked the wiring, voltages etc etc and yes well... from one side of the plug i get a voltage reading of about 4.75 volts (this is a cheap well battered multi meter so will not...
  6. autobox selector shaft and sender damaged

    Range Rover Mark II / P38
    Hello all, 2001 4.6L. Front propshaft came adrift when the rear UJ failed, and whacked the side of the gearbox, bending the gearbox selector shaft up and damaging the xyz sender. Can I replace the shaft part via the sump, or should I just be looking for another gearbox? rgds Alan
  7. Fuel Pump and Fuel Sender

    Range Rover Mark II / P38
    Still working thru the issues on my 1998 4.6 HSE brings me to the last few issues, I had a diagnostic report on a starting issue (cranks 2 or 3 times before spluttering and firing).. the fuel pump was pressure tested at (20-0 Bleeds off) and a new pump recommended. Now the fuel gauge does not...
  8. cold start problem is it fuel sender or temp sensor

    Range Rover Mark II / P38
    hi my range rover p38 diesel has been very hard to start over the winter,have replaced glow plugs and bleed off pipes,car was better but still not right. after reading quite a few related items on you forum ,it seemed to point to the in tank fuel sender , BUT in the recent warm spell my car...
  9. Crankcase Position Sender, can someone what the oms reading should be?

    Range Rover Mark II / P38
    Crankcase Position Sender, can someone what the oms reading should be? HI, P38 1998 4.6. Can someone tell me what the correct oms reading should be for the CPS, i had a starting problem, removed CPS and got a reading of 1.2. Also cleaned maf sensor, and P38 fired up straight away with no fuel...
  10. Fuel level sender

    Range Rover Classic
    Just been searching here and through my repair manuals but have not found the details i need. Does anyone know please what the actual resistance (ohms) is of the sender when the float lever is at at the total up point and when it's at the total down position. I plan to install a new guage that...
Top