Range Rovers Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-15 of 15 Results
  1. Range Rover Mark III / L322
    New to me vehicle. When I tried to operate the rear washer after replacing a wiper blade I noticed a puddle of fluid appearing approximately under the DS exhaust manifold explaining why the rear wiper was not performing well. It looks like a PO decided to disconnect the rear wiper hose for...
  2. Range Rover Sport II / L494
    Hi I have had my RRS SDV6 for two weeks. It has incontrol pro with live traffic. I am in Sydney, Australia The GPS is coming up with some very strange routes which include numerous illegal right turns at major intersections. Its general routing is also strange - have a look at the pic. It was...
  3. Range Rover Mark IV / L405
    Hi , does anyone know how or where I can run wiring from the engine bay through to the inside of the car so I can switch on my new Led spot lights ? I can not see any where in the engine bay that has wiring going back through to the inside of the car. Thanks.
  4. Range Rover Classic
    i am putting my engine back in, and i am finding my notes to be incomplete. i remember having to remove some wires both fixed and clamped at the back of the engine, but for the life of me, i can not find any notes on which wires were attached/routed. i found my grounds, and i know they attach...
  5. Range Rover Mark III / L322
    ...does someone have a diagram of how to route this thing.
  6. Range Rover Mark II / P38
    Greetings all. I spent my Saturday inspecting the vacuum lines on a new to me 2001 P38 in am effort to track down a slightly rough idle. ( the OBD reader has been ordered) I found a strange hose, possibly part of the fuel evac system which I cannot identify through RAVE or the search function...
  7. Range Rover Mark III / L322
    Seems like things are starting to need replacing all at once. I have a misfire on 3, pretty sure it's the ignition coil but can't check because now my Rover won't start. Went to drive home from a friends Saturday evening and there was a loud squeal coming from under the hood. Got home and...
  8. Range Rover Mark II / P38
    Hello, I just purchased a 1998 P38 and the tubes were missing off of the cruise control, can any 1 link/post pictures or routing manual on where each 1 goes, haven't been able to find much online, and nobody in my town has a Range Rover for me to peak under the hood. Thanks!
  9. Range Rover Classic
    I have a NAS 1995 Range Rover classic with a 4.2 v8. I'm reinstalling the engine after someone else removed it. I am unable to figure out where one vacuum line is supposed to go. The line in question is from the vacuum switch that controls the water valve for the heat, to wherever it originates...
  10. Range Rover Mark III / L322
    I took it upon myself to replace the serpentine belts on my 2006 Range Rover HSE 4.4L V8. Only thing is that after removing the belt I didn't pay attention to the routing. There for I'm lost to the correct routing. I found some diagrams and tried it but my engine temp overheat. I didn't have...
  11. Range Rover Mark III / L322
    I'm right in the middle of changing my PCV valve on my 4.4 V8 engine, but unfortunately there is a hole in the small vacuum hose that attaches to the front of the PCV valve. The hose is very tight as it disappears under the manifold and the hole is in a position that makes it impossible to fit a...
  12. Range Rover Mark III / L322
    Hi everyone, Great to be here! - I have a 2004 Range Rover Vogue TDV6 and want to connect a front camera to the TFT screen in the cabin. Can anyone advise me as to the easiest way I can run a cable through the firewall in the engine bay? Many thanx in advance.
  13. Range Rover Mark III / L322
    Fellow Rovers' 2003 RR LIII. Have error codes of P1171 and 1174. Replaced the MAF and replaced the Cabin filter, part of regular maintenance. There appears to be a vacuum disconnect under the Cabin filter. I see two vacuum hoses: one is clear plastic that is bundled with electrical coming...
  14. Range Rover Mark II / P38
    I've been looking through RAVE, trying to figure out the spark plug wiring routing. Where is it located for a bosch motor? thanks
  15. Range Rover Mark III / L322
    Hi, Without stripping my car to have a look, can anyone tell me where the loom runs from the numberplate light power lines through to pins 5 & 12 of the D183 Module-Lighting Switch? I have a problem with the numberplate lights so I intend to rewire them into the rear sidelights and am hoping...
1-15 of 15 Results